To protect the solenoid from overheating, the solenoid operation stops automatically in 4 seconds, and then the solenoid will not respond to commands for an additional 20 seconds. (m) Enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Air Bleeding. (j) Turn the engine switch off and connect the Techstream to the DLC3. Therefore, always use the Techstream when bleeding air. If air is bled without using the Techstream, damage or accidents may result. (l) Check and adjust the brake fluid level. (i) Bleed the air from the bleeder plug of the rear disc brake cylinder LH using the same procedure as for the RH side. (h) When there is no more air in the brake fluid, tighten the bleeder plug, and then release the brake pedal. As brake fluid is continuously drained while the pump operates, it is not necessary to repeatedly depress the brake pedal.Be sure to release the brake pedal to stop the motor after approximately 100 seconds of continuous operation.
(g) With the brake pedal depressed, loosen the bleeder plug of the rear disc brake cylinder RH, continue to hold the brake pedal and allow brake fluid to be drained from the bleeder plug while the pump motor operates. (f) Bleed the air from the bleeder plug of the front disc brake cylinder LH using the same procedure as for the RH side. (e) Repeat the step above until the air is completely bled, and then tighten the bleeder plug while depressing the brake pedal. (d) Repeatedly depress the brake pedal and bleed air from the bleeder plug of the front disc brake cylinder RH. (c) Add brake fluid until the fluid level is between the MIN and MAX lines of the reservoir. (b) Remove the brake master cylinder reservoir filler cap assembly.
#TECHSTREAM AUTO BELLEVUE MANUAL#
Here's what the manual says on the subject: Unless you make fluid move through the ABS (alternate - maybe panic stopping on wet grass?) you can't get a 100% flush.
Techstream allows one to energize the ABS block and flush any fluid in it (happens down in the lower part of the text below beginning with line "m". Not using Techstream flushes the lines only.
0 kommentar(er)
